Motorola MTM5 00 Series Basic Service Manual page 43

Test Setup & Testing for 380–430 MHz
4. Configure the parameters for the "System ID and Access Parameters".
5. Configure the parameters for the "Mobile Parameters".
6. Configure the parameters for the "Call Types".
7. Configure the parameters for the "Call Timers and Trunking".
8. Configure the parameters for the "Neighbor Cell Info".
a. Press the "Config" soft key twice, then go to "Configure", followed by "System ID
& Access Parameters", and press the "Select" soft key.
b. Enter the parameters outlined below:
Mobile Country Code (MCC):
Mobile Network Code (MNC):
Base Station Color Code (BCC):
Location Area Code (LA):
a. Press the "Config" soft key twice, then go to "Configure", followed by "Mobile
Parameters", and press the "Select" soft key.
b. Enter the parameters outlined below:
Short Subscriber Identity (SSI):
Group Short Subscriber Identity (GSSI):
Power Class:
Receiver Class:
Note: The number for Short Subscriber Identity (SSI) and Group Short Subscriber
Identity (GSSI) base on the number key in the Codeplug of the radio.
a. Press the "Config" soft key twice, then go to "Configure", followed by "Call
Types", and press the "Select" soft key.
b. Enter the parameters outlined below:
Priority:
Calling Party SSI:
a. Press the "Config" soft key twice, then go to "Configure", followed by "Call Timers
& Trunking", and press the "Select" soft key.
b. Enter the parameters outlined below:
Trunking Type:
Simplex Traffic Channel Type:
Test Set Transmit Mode:
c. Leave the rest of the parameters in their default values.
a. Press the "Config" soft key twice, then go to "Configure", followed by "Neighbor
Cell Info", and press the "Select" soft key.
234
2392
1
224
(use fixed) 100
(use fixed) 3001
(use fixed) 3 (40.0dBm / 10W)
(use fixed) B
00 = Priority Not Defined
100
Transmission
DL and UL TCH
Continuous
5.1 - 5