Table of Contents
Advertisement
Test Setup & Testing for 380–430 MHz
6. Press any key consecutively. The display shows the backlight brightness levels
7. Press any key to start the next test. The display shows "Keypad backlight test".
8. Press any key again. The display shows "Keypad backlight is off". Verify that the key-
9. Press any key again. The display shows "Keypad backlight is on". Verify that the
10. Press any key to start the next test. The display shows "Emergency backlight test".
11. Press any key consecutively. The display shows the emergency button brightness
12. Press any key to start the next test. The display shows "Status LED test".
13. Press any key again. The display shows "Red LED is on" and the Red LED at the
14. Press any key again. The display shows "Green LED is on" and the Green LED at the
15. Press any key. The display shows "Orange LED is on" and the orange LED at the
16. Press any key consecutively. The display shows the LED brightness levels "min",
17. Press any key to start the next test. The display shows "Keypad test".
18. Press any key again. The display shows all the radio keys.
19. Press every key, one by one. Each key you press causes its respective display to be
20. Press any key to start the next test. The display shows "Rotary test".
21. Turn the rotary switch clockwise and counter clockwise. Each step causes the
22. Press the rotary push button consecutively until "OK" is highlighted.
23. Press any key to start the next test. The display shows "Fist MIC test".
24. Press any key to continue. Connect a fist microphone. The display shows "Accessory
25. Press PTT to highlight all "0".
26. Place the microphone on / off hook to highlight all "0".
27. Press any key again. The display shows "End of user tests", "Press any key to power
28. This completes the test. Press any key to turn the radio OFF.
"min", "low", "med" and "max". Verify the brightness of the display.
Note: At level "min" the display contents is not visible.
pad backlight is off.
keypad backlight is on.
levels "min", "low", "med" and "max". Verify the brightness of the emergency button.
right side of the radio is lit.
right side of the radio is lit.
right side of the radio lit.
"low", "med" and "max". Verify the brightness of the orange LED at the right side of
the radio.
highlighted. If you press a highlighted key again, the highlighting is removed. To exit
this test before all keys are highlighted press the rotary push button.
respective displayed arrow sign to be highlighted. Turn the rotary switch until the two
respective "OK" labels are highlighted.
connected".
off or use softkeys to scroll to any previous test".
5.1 - 15
Advertisement
Table of Contents
