Motorola MTM5 00 Series Basic Service Manual page 46

5.1 - 8
14. Press the "Location Area" soft key.
15. Press the "Min Rx Level" soft key.
16. Press the "Max Tx Level" soft key.
17. Press the "Access Parameter" soft key.
18. Press the "Test Mode" soft key. Press the "Enable" soft key.
19. Press the "Base Service" soft key.
20. Press the "Support" soft key if it is displayed
21. Press the "Return" soft key.
22. Press the "Neighbr Cell" soft key.
23. Verify that the following values are displayed:
24. Press the "Return" soft key.
25. Verify that "Trunking Type" is set to "Message".
26. Press the "Call Type" soft key to enter the "Call Type" screen.
27. Press the "Private Call" soft key.
28. Press the "Simplex Duplex" soft key and "Simplex Call" soft key.
Thereafter, enter "224" and press the "Location Area" soft key.
Thereafter, enter "-110dBm" and press the "Min Rx Level" soft key.
Thereafter, enter "40dBm (10W)" and press the "Max Tx Level" soft key.
Thereafter, enter "-33dBm" and press the "Access Parameter" soft key.
or verify that the following values are displayed:
POWER ON REGISTRATION:
POWER OFF DE-REGISTRATION:
PRIORITY CELL:
MINIMUM MODE SERVICE:
MIGRATION:
SYSTEM WIDE SERVICE:
TETRA VOICE SERVICE:
CIRCUIT MODE DATA SERVICE:
(RESERVED):
SNDCP SERVICE:
AIR INTERFACE ENCRYPTION:
ADVANCED LINK:
Note: The displayed values are factory defaults and should not be changed.
NEIGHBOUR CELL BROADCAST:
BROADCAST INTERVAL:
NEIGHBOUR CELL CHANNEL:
NEIGHBOUR CELL LOCATION AREA:
NEIGHBOUR CELL IDENTIFIER:
SLOW RE-SELECT THRESHOLD:
SLOW RE-SELECT HYSTERESIS:
FAST RE-SELECT THRESHOLD:
FAST RE-SELECT HYSTERESIS:
Note: The displayed values are factory defaults and should not be changed.
Test Setup & Testing for 380–430 MHz
REQUIRED
REQUIRED
YES
NEVER USED
SUPPORTED
NORMAL MODE
SUPPORTED
SUPPORTED
NOT AVAILABLE
NOT AVAILABLE
NOT AVAILABLE
NOT SUPPORTED
NOT REQUIRED
10s
0000
00001
01
10dB
10dB
10dB
10dB