Brother DCP-750CW Network User's Manual page 81

Gateway
This field displays the current gateway or router address used by the machine. If you are not using DHCP or
BOOTP to obtain the gateway or router address, enter the address you wish to assign. If you do not have a
gateway or router, leave this field blank. Check with your network administrator if you are unsure.
a
Press Menu.
b
Press a or b to select LAN.
Press OK.
c
(For Wired) Press a or b to select TCP/IP(Wired).
(For Wireless) Press a or b to select TCP/IP(WLAN).
Press OK.
d
Press a or b to select Gateway.
Press OK.
e
Press a or b to select Change.
Press OK.
f
Enter the Gateway address.
Press OK.
Note
For DCP models, press a or b repeatedly to enter the first three-digit number for the Gateway address.
Press c to enter the second three-digit number. Repeat this step until you have entered the fourth three-
digit number to complete the Gateway address. Press OK.
g
Press Stop/Exit.
Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRN_xxxxxx for a wired network or BRW_xxxxxx for a wireless network (where xxxxxx is the last six digits of
the Ethernet address) (up to 15 characters).
a
Press Menu.
b
Press a or b to select LAN.
Press OK.
c
(For Wired) Pressa orb to select TCP/IP(Wired).
(For Wireless) Press a or b to select TCP/IP(WLAN).
Press OK.
d
Press a or b to select Node Name.
Press OK.
Control panel setup
6
6
6
74