Hose Storage - Craftsman CMXEVBE179250 Instruction Manual

Hose Storage (Fig. V & W)
Wrap the Pos-I-Lock® Hoses around the Upper Storage
Rack and around the Wet/Dry Vac unit, as shown.
CAUTION:
!
Do not operate vacuum while the hose is still wrapped
around the powerhead assembly in the storage
position.
WARNING:
!
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings blocked;
keep free of dust, lint, hair or anything that may reduce
air flow.
Fig. V
Wand
Storage
12
SP7085-2 CMXEVBE179250.indb 12
NOTE: The Pos-I-Lock® Hose has an Adaptor that can
be used to connect the Hose to the Female Port on the
Vac or to the Male End of another Hose. Both 7-foot
(2.1 m) and 14-foot (4.3 m) Hoses can be used either
connected together or independently from one another.
The 14-foot (4.3 m) Hose has a Locking Adaptor at one end
that will connect to the Vac, and a Friction Fit Connector
at the other end, which will connect to all the 1-7/8-inch
(2.5 cm) Accessories or a Second Hose.
The 7-foot (2.1 m) Hose has a Locking End at both
ends of the Hose. The larger of these Ends is sized to
connect to the Vac or to the Friction Fit End of the 14-foot
(4.3 m) Hose and the smaller of these Ends is sized to Lock
to all the 1-7/8-inch (2.5 cm) Accessories.
To connect these Two Hoses together, first connect the
14-foot (4.3 m) Hose to the Wet/Dry Vac. Next connect
the 7-foot (2.1 m) Hose to the 14-foot (4.3 m) Hose by
inserting the Friction End of the longer Hose into the larger
Locking End of the shorter Hose. This will create a Friction

Hose Storage

Connection.
Rack
Fig. W
SIDE VIEW
Female Port
on Vac
Adaptor
Male End
of Hose
10/24/19 12:48 PM