Power Head Assembly; Insert Hose - Craftsman 113.170660 Owner's Manual

Positioning Detachable Blower
(Power Head Assembly)
1. Locate the detachable blower of your
Craftsman Wet/Dry Vac.
2. On top of the blower (opposite the
handle side of the blower); there is
molded plastic lead that is used to
assist assembling the unit. Position the
lead into the indented area above the
label.
3. Rotate the detachable blower down
until the travel of the unit stops.
4. Lightly press down on the carry handle
of the detachable blower until the
power head latch engages the blower.
The detachable blower is now latched
to the lid assembly.
Insert Hose
Insert the hose locking end of the "Pos-I-
Lock" hose into the inlet of the vac. The
hose should snap into place. To remove
the hose from the vac, press the release
button in the hose assembly and pull the
hose out of the vac inlet, as shown.
Your new Wet/Dry Vac is ready for use.
Detach
Blower
Power
Bead
Latch
PRESS &
PULL
Release
Button