Vac Assembly; Insert Hose; Accessory Storage - Craftsman CMXEVBE175840 Instruction Manual

Vac Assembly (Fig. F)
1. Line up front (label side) of Powerhead Assembly with
Vac Inlet located on the front of the Drum.
NOTE: Powerhead Assembly must be aligned with Drum
for proper attachment.
2. Place Powerhead Assembly on top of Drum.
3. Be sure Powerhead Assembly completely covers the
top of the Drum so leakage does not occur.
4. Press down on the Lid Latches to securely attach the
Powerhead Assembly to the Drum.
5. To remove the Powerhead Assembly, first unplug the
unit from the electrical outlet. Then lift up on the Lid
Latches and remove from Drum.
Fig. F
20 Gallon (75 Liters) Shown
Insert Hose (Fig. G)
Insert the Locking End of the Hose Assembly into the Vac
Inlet. The Hose should snap into place.
To remove the Hose from the Vac, press the Release Button
on the Hose Assembly and pull the Hose out of the Vac
Inlet, as shown.
SP7075-1 6, 9, 12, 16, 20 Gallon 2019.indb 7
Fig. G
20 Gallon (75 Liters) Shown
Accessory Storage (Fig. H)
Your Accessories may be stored in the Caster Feet or
Powerhead
in the storage locations on the Powerhead Assembly
Assembly
(in applicable models).
Label
The Hose may also be stored by wrapping it around the
unit and securing it into the Hose Clips (in applicable
Lid
Latches
models).
CAUTION:
!
Vac
Do not operate vacuum while the hose is still wrapped
Inlet
around the powerhead assembly in the storage
position.
WARNING:
!
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings blocked;
keep free of dust, lint, hair or anything that may reduce
air flow.
Fig. H
20 Gallon (75 Liters) Shown
Vac Inlet
Release
Button
Hose
Powerhead Assembly
Storage for Accessories
Hose
Hose Clips
Caster Feet Storage
for Accessories
2/22/19 10:31 AM
7