Jenn-Air JUCFP242HL11 Owner's Manual page 14

User adjusts any of the compartment temperatures.
Cool Off Mode is entered (activated by user).
Sabbath Mode is entered (activated by user).
After 24 hours, the temperature will automatically
return to the previous temperature set point and the
indicator light will turn Off.
NOTE: If the previous temperature set point was set to
Soft Serve in the freezer drawer, the temperature will
return to the recommended temperature 0 °F (-17.7
°C) instead when Max Cool is complete.
3. Ice Maker and Water Filtration System
(Refrigerator/Freezer Drawers only)
IMPORTANT:
After connecting the
refrigerator to a water source
or replacing the water fi lter,
fi ll and discard three full
containers of ice to prepare
the water fi lter for use before using ice.
TURNING THE ICE MAKER ON/OFF:
IMPORTANT:
Use the Icemaker touch pad on the control panel to
turn on or off the ice maker. Do not adjust the wire arm
located on the ice maker.
Press the ICEMAKER touch pad to turn on the ice
maker. The indicator light will illuminate when On.
Press the ICEMAKER touch pad to turn off the ice
maker.
REMEMBER:
Allow 24 hours to produce the first batch of ice.
The quality of your ice will only be as good as the
quality of the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor
quality ice. If a softened water supply cannot be
avoided, make sure the water softener is operating
properly and is well maintained.
Do not store anything in the ice storage bin.
When the refrigerator is turned ON for the first time,
ice maker is turned OFF. (The ice maker indicator light
will dim).
After confirming that water can be automatically
supplied to the ice maker (connecting the refrigerator
to the water source or replacing the water filter, press
the ICEMAKER touchpad to turn on the ice maker.
(The indicator light will iluminate). When the water
cannot be supplied automatically (not connecting to
the water source, etc.) and the ice box is not filled
with ice, if the ice maker is turned ON, the ice maker
will continue to operate and the internal heater of ice
maker will operate frequently. This will heat up the
14
refrigerator, increasing the compressor running rate
and power consumption. If you do not need the ice
making (including not automatically supplying water),
you should turn OFF the ice maker. (The indicator
light will dim).
4. Using Presets:
For your convenience, each drawer also has controls
that are preset to recommended storage temperatures
for specific products.
Style 1: Refrigerator drawer models
Style 2: Refrigerator/freezer combo models
Pressing any preset option will set the temperature
value to recommended temperature for each category:
Refrigerator drawers:
Produce: 39 °F (3.8 °C)
Assorted: 37 °F (2.7 °C)
Beverage: 34 °F (1 °C)
Meat: 32 °F (0 °C)
Freezer drawer:
Soft Serve: 6 °F (-14.4 °C)
NOTE: Soft Serve is a temporary temperature setting
that will only last for 4 hours and returns to the previous
temperature set point when complete.
Assorted: 0 °F (-17.7 °C)
Spirits: -2 °F (-18.8 °C)
Deep Freeze: -8 °F (-22 °C)
5. Adjusting the Temperatures:
When the refrigerator drawers
are turned On for the fi rst
time, a recommended
temperature is set by
default. The controls adjust
the temperature of both
compartments independently.
To adjust set point temperatures, press "+" (plus) or "-"
(minus) until the desired temperature setting is reached.
Model JUDFP242*
NOTE: The set point for the double refrigerator drawers
model is 37 °F (2 °C). The set point range for this model
is 32 °F to 42 °F (0 °C to 5 °C) for both compartments.