Move The Refrigerator Drawers To Final Location; Install Custom Overlay Panel - Jenn-Air JUCFP242HL11 Owner's Manual

4.
The ice maker is equipped with a built-in water
strainer. If your water conditions require a second
water strainer, install it in the 1/4" (0.63 cm) water line
at either tube connection. Obtain a water strainer
from your nearest appliance dealer.
5.
Plug in refrigerator drawers or reconnect power.
MOVE THE REFRIGERATOR DRAWERS
TO FINAL LOCATION
1.
Place top of cardboard carton or plywood under the
appliance. Remove dolly.
2.
Do not remove film or cover.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3.
Plug into a grounded 3 prong outlet.
Excessive Weight Hazard
Use two or more people to move and install or uninstall
appliance.
Failure to do so can result in back or other injury.
4.
Move the refrigerator drawers straight back and
evenly in front of the opening.

INSTALL CUSTOM OVERLAY PANEL

IMPORTANT:
For standard stainless steel models, skip these
instructions and go to "Level The Refrigerator
Drawers" section.
Create a custom overlay panel according to the
specifi cations in "Custom Overlay Drawer Panels."
JennAir is not responsible for the removal or addition
of molding or decorative panels that would not allow
access to the refrigerator for service.
ATTACH THE OVERLAY PANEL:
NOTE: If the overlay hooks are not installed, see
"Custom Overlay Drawer Panels" for overlay hook
locations. The location of the hooks must be as precise
as possible. If the custom panel is incorrectly placed,
the panel may interfere with optimal use of the
drawers.
1.
Attach the custom handle of your preference on the
overlay before attaching the overlay to the drawer of
the refrigerator.
NOTE: Custom handles may vary in dimensions.
Holes must be made on the panel according the
specific dimensions of your handle.
2.
Attach the hooks to their corresponding recessions
on the panel, using the SS Flat M4x12 screws.
Two screws are needed per hook. The hooks must
be on the outer edge of the panel.
A
A- 4 wood screws
3.
Gently pull back the gasket from the top corners of
the door until you can see the screw that is behind
the gasket. There is one screw on each side. It is not
necessary to remove the gasket.
4.
Remove the screws behind the gasket (one per side).
5.
Align the panel to the drawer and position the
overlay panel 1/2" (12.5 mm) higher than the door.
Position the overlay hooks with the pilot holes and
push the hooks into the holes. The drawer has
insulant foam in its interior so you may feel some
interference while pushing. Push until the hooks go
through the foam.
6.
Push straight down on the overlay panel to secure
the overlay hooks to the drawer.
7.
Using the self-tap wood screws (two per drawer; one
in each corner of the drawers), attach the panel to
the drawer.
NOTE: Do not put the screws removed in step 4 back
on the door.
8.
Once the overlay is securely attached to the drawer
with the two screws, put the gasket back in its place
by pressing it against the door until the gasket is
even and firmly secured.
11