Accessory List - Brother FAX-717 User Manual

Accessory List

Model Name
PC-401
PC-402RF
PC-404RF
PC-AS4RF
*For optimum print quality and product performance within published specifications, use
only the correct Brother replacement ribbon. Failure to use the genuine Brother consumable
may damage the machine and such damages will not be covered under warranty.
Change Answer Mode
Press 9 8.
then for TAD, press 1.
(For FAX-717/727)
Exit Remote Operation
Press 9 0.
Change Remote Access Code
1
2
3
4
(For FAX-737MC)
Retrieve a Fax
Press 9 6.
then to Print a Memory Status List press
1, then enter the number of remote
fax machine, and then # #. After
the beep, hang up and wait.
Retrieve all faxes press 2, then
enter the number of remote fax
machine, and then # #. After the
beep, hang up and wait.
Erase all fax messages press 3.
Check Receiving Status
Press 9 7.
then for Fax message, press 1.
Voice message, press 2.
1 long beeps – received messages
3 short beeps – no messages
Description
Printing Cartridge and a re-fill (1 set per box)
2 re-fills for use in PC-401 Printing Cartridge
4 re-fills for use in PC-401 Printing Cartridge
4 re-fills for use in PC-401 Printing Cartridge
(Not available in Australia and New Zealand)
Fax/Telephone (F/T), press 2.
Fax, press 3.
Press Menu/Set, 8, 3.
Enter a three- digit number. The cannnot be changed.
Press Menu/Set.
Press Stop/Exit.
Change Answer Mode
Press 9 8.
then for Message Centre, press 1.
Exit Remote Operation
Press 9 0.
5
R
Using Remote Access Code
1
2
3
4
5
6
4
Fax/Telephone (F/T), press 2.
Fax Only, press 3.
C A
EMOTE ONTROL
Dial your machine phone number from a touch tone
phone.
Enter your Remote Control Access Code (3 digits
followed by ) after the beep.
Your machine signals the kinds of messages received:
1 long beeps – Fax message(s)
No beeps – no messages
After 2 short beeps, enter a command.
Press 9 0 to reset your machine when you finish.
Hang up.
M M
ESSAGE ANAGER
R C
EMOTE ONTROL
Using Remote Access Code
1
Dial your fax machine phone number from a
touch tone phone.
2
Enter your Remote Control Access Code
(3 digits followed by ) after the beep.
3
The fax machine signals the kinds of
messages received:
1 long beep – Fax message(s)
2 long beeps – Voice message(s)
3 long beeps – Fax and Voice message(s)
No beeps – no messages
4
After 2 short beeps, enter a command.
5
Press 9 0 to reset the machine when you
finish.
6
Hang up.
6
C
CCESS ARD
1
A C
CCESS ARD
1
114