Table of Contents
Advertisement
88
C H A P T E R T E N
Remote Retrieval
See Operation
from Extension
Telephone
p. 39
This section is for the FAX 870MC and MFC 970MC. (If you have the FAX 770,
please see Chapter 9 for your remote fax options.) You can call your FAX/MFC
from any touch tone phone (or remote Group 3 fax machine) and use a Remote
Access Code and other button presses to retrieve voice (and fax) messages. You can
also program and change some settings for your Message Center.
Using Remote Access Code
1
Dial your FAX/MFC phone number from a touch tone phone.
2
When your FAX/MFC answers and beeps, immediately enter your Remote
Access Code.
3
The FAX/MFC signals the kinds of messages received:
1 long beep—Fax message(s)
2 long beeps—Voice message(s)
3 long beeps—Fax and Voice message(s)
No beeps—no messages
4
The FAX/MFC then prompts you with two short beeps to enter a command.
If you wait longer than 30 seconds to enter a command, the MFC hangs up.
If you enter an invalid command, the FAX/MFC beeps three times.
5
Press
to reset the FAX/MFC when you finish.
9
0
Hang up.
6
If your FAX/MFC is set to MANUAL mode, you can access the Message Center by
waiting about 2 minutes, then entering the Remote Access Code within 30 seconds.
Changing Remote Access Code
Enter your Remote Access Code when the FAX/MFC picks up your call, so
you can access features remotely. The access code is preset to 159 , but
you can change this.
1
Press
,
,
Function
8
2
Enter a three-digit number from 000 to 999. The " " cannot be changed.
Do not use the same digits that appear in your Fax Receive Code,
Telephone Answer Code, or Personal Mailbox Codes.
3
Press
.
Set
4
Press
to exit.
Stop
.
7
Advertisement
Table of Contents
