Remote Commands
96
Retrieve a fax
1 Memory Status List
2 Retrieve all faxes
3 Erase fax in the memory
97
Check the receiving status
1 FAX
2 VOICE
98
Change Answer Mode
1 MSG CTR
2 FAX/TEL
3 FAX
90
Exit
Retrieving Memory Status List
You can retrieve the Memory Status List from a remote fax machine to see if you have
any fax messages.
1
Dial your fax number.
2
When you hear the beep, immediately enter your Remote Retrieval Access Code
(1 5 9
).
3
When you hear two short beeps, use the dial pad to press 9 6 1.
4
Using the dial pad, enter the number of the remote fax machine (up to 20 digits) where
you want the Memory Status List forwarded, and then press # #.
You can not use
press #.
5
After you hear your FAX/MFC beep, hang up and wait.
Your FAX/MFC calls the remote fax machine. The remote fax machine prints the
Memory Status List.
Enter the number of a remote fax machine to
receive a report or stored fax messages. (See
page 9-10.)
If you hear one long beep, you can erase the fax
message from the memory.
You can check whether your FAX/MFC has
received any FAX or VOICE messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
If you hear one long beep, you can change the
answer mode. If you hear three short beeps,
you cannot change it. (Example: There is no
MSG CTR OGM when you want to change to
MSG CTR mode.)
After a long beep, you can exit remote control.
or # as dial numbers. However, if you want to store a pause,
Operation Details
M E S S A G E C E N T E R
9 - 10