Engine Shut-Off Cord (Lanyard) And Clip - Yamaha VF115 Owner's Manual

Hide thumbs Also See for VF115:
Table of Contents

Advertisement

Available languages

Available languages

1
1. Cap
2.
To increase resistance, turn the adjuster
clockwise. To decrease resistance, turn
the
adjuster
WARNING! Do not overtighten the fric-
tion adjuster. If there is too much re-
sistance, it could be difficult to move
the remote control lever, which could
result in an accident.
1. Throttle friction adjuster
1
1. Throttle friction adjuster
ZMU06904
counterclockwise.
[EWM02581]
1
ZMU07026
ZMU06989
3.
Install the cap.
EMU25996

Engine shut-off cord (lanyard) and clip

The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord during
normal operation. Loss of engine power
means the loss of most steering control.
Also, without engine power, the boat
could slow rapidly. This could cause peo-
ple and objects in the boat to be thrown
forward.
[EWM00123]
1. Engine shut-off cord (lanyard)
2. Clip
3. Engine shut-off switch
Components
1
ZMU07027
3
2
27

Advertisement

Chapters

Table of Contents
loading

Table of Contents