Throttle Friction Adjuster; Engine Shut-Off Cord (Lanyard) And Clip; Engine Stop Button; Choke Knob - Yamaha 2D Owner's Manual

Components
EMU25982

Throttle friction adjuster

An adjustable friction device within the
aprons restricts movement of the throttle le-
ver according to the operator's preference.
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EWM01481
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to move the throttle lever, which
could result in an accident.
EMU25996

Engine shut-off cord (lanyard) and clip

The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not
route the cord where it could become en-
tangled, preventing it from functioning.
Avoid accidentally pulling the cord during
normal operation. Loss of engine power
15
means the loss of most steering control.
Also, without engine power, the boat
could slow rapidly. This could cause peo-
ple and objects in the boat to be thrown
forward.
ZMU02597
1. Engine shut-off switch
2. Clip
3. Engine shut-off cord (lanyard)
EMU26004

Engine stop button

The engine stop button stops the engine
when the button is pushed.
1. Engine stop button
EMU26051

Choke knob

To supply the engine with the rich fuel mix-
ture required to start, turn this knob counter-
clockwise.
[EWM00123]
2
1
3
ZMU02598
1
ZMU02650