Connect Vigortalk To Your Phone And Network; With General Adsl Router - Draytek VigorTalk ATA User Manual

2.1 Connect VigorTalk to Your Phone and Network

2.1.1 With General ADSL Router

If the router act as an DHCP server, to use the Web GUI, you only need to
connect both the PC and VigorTalk to the router. They should be assigned IP
addresses at the same subnet by the router.
1 Use a standard RJ-45(Ethernet) cable to connect the LAN port of
VigorTalk and the router.
2 Use a standard RJ-11 (telephone) cable to connect the Phone port of
VigorTalk and the touch tone telephone.
Note: Do not connect RJ-11 (telephone) cable to the wall jack
3 Connect the power adapter (included) to the receptor of VigorTalk and
plug the other end of the power adapter to a wall outlet to power on the
unit.
4 Via the phone key pad, press "***#" to enter the VigorTalk IVR. You will
hear the welcome message.
5 Press "41#" to "Check the IP Address". You will hear the IP address of
VigorTalk. Write down and then hang up.
For further detail of IVR, please refer to the section 2.3.
6 Open your Web browser and enter http://(VigorTalk IP Address that you
heard). Enter the default password "vigortalk" and leave the
administrator filed blank in the window.
7 You may start configure VigorTalk via WebUI now.
For more detail of Web UI, please refer to the section 2.2.
VigorTalk ATA
5