Installation And Configuration - Draytek VigorTalk ATA User Manual

2 Installation and Configuration

If this product is provided to you by the service provider or network
administrator, pre-configuration of network and service settings may have
been applied. You, as end-user, may be limited to access local configuration
settings. Then you should follow the installation instruction provided by
your provider.
Depending on the service policy, if end user configuration is permitted, please
follow the major instructions described below. For more detail, please refer to the
VigorTalk User's Guide.
To locally configure the VigorTalk, you should have the equipments and
information below:
1. A touch tone telephone
2. Ethernet-based Cable or DSL modem or General ADSL router, e.g. Vigor 2900
(or a router plus a Ethernet-based Cable or DSL modem will work equally)
3. An established Internet account from an Internet Service Provider (ISP), including
IP Address Subnet and Gateway Address or DHCP availability.
4. SIP Proxy Address and Registration Information from SIP Registrar (e.g. DrayTEL)
DrayTek provides two interfaces for configuration. You may need to use both for
initial installation.
DrayTek IVR(Interactive Voice Response)*
Web GUI
* Interactive Voice Response (IVR) is an automated voice system which allows caller
can navigate the function menus created by providers using their telephone keypad.
VigorTalk ATA
4