Bosch Evolution HDS7052U Conversion Manual page 7

Adjust Bake Burner Ori-
fice
extension to turn orifice clockwise until it stops (2- 2 1/2 turns). DO NOT
OVERTIGHTEN.
CAUTION: DO NOT overtighten the broil burner orifice. Overtighten-
ing may result in damage to the pin inside the orifice. This affects cooking
performance. It could cause inconsistent flames and unintentional release of
carbon monoxide.
Natural Gas Setting
6. Replace Broil Assembly. Replace broil assembly being careful to feed all
wires through back wall of oven. Reinsert all 7 screws.
Note: The air shutter on the broil burner fits over the orifice when installed
correctly.
The bake burner orifice is located below the air shutter (See Figure 6). Reach it
through the access hole in the interior back panel of the warming drawer cavity.
Broil Orifice
Tightened, but not fully seated
LP Gas Setting
Figure 5: Broil Orifice Conversion
Conversion
Figure 4: Broil Orifice
English 5