Installation; Ventilation; Power; Connecting Composite Video Signal To The Monitor - Bosch LTC-2915-91 Instruction Manual

LTC 2915/91, LTC 2917/91, & LTC 2919/90 | Instruction Manual | Installation
4

INSTALLATION

4.1

Ventilation

To prevent overheating, ensure that the ventilation
openings on the monitor are not covered.
4.2

Power

Model Rated
No. Voltage
LTC 2915/91 120/230VAC
50/60Hz
LTC 2917/91 120/230VAC
50/60Hz
LTC 2919/90 120/230VAC
50/60Hz
The LTC 2915/91, LTC 2917/91, and LTC 2919/90
monitors are delivered with a 3-pole US style power
cord and a 3-pole Euro style power cord. The US
style power cord is used where 120VAC, 60Hz power
is available, and the Euro style power cord is used
where 230VAC, 50Hz power is available. The
monitor end of the power cord plugs into mains input
socket (Figure 1, Item 11) on the rear panel. The
monitor automatically adjusts to either power input
voltage. A power ON/OFF switch is located on the
front of the unit (Figure 1, Item 7).
4.3
Connecting Composite Video
Signal to the Monitor
The four (4) BNC connectors (Figure 1, Item 9)
located on the rear of the monitor are for composite
video inputs and outputs.
In
Out
NOTE: All video inputs are passive loop-through.
Bosch Security Systems | 10 June 2004
Voltage Power at Sync
Range Rated Format
Voltage
100 to 240 80W PAL/
NTSC
100 to 240 90W PAL/
NTSC
100 to 240 100W PAL/
NTSC
Video
4.4 Connecting Y/C (S-video) Signal
to the Monitor
There are two (2) mini-DIN type connectors
(Figure 1, Item 10); one for Y/C input (IN) and
one for a loop-through Y/C output (OUT) to another
device.
Video
NOTE: The video input is passive loop-through.
4.5

Connecting Audio to the Monitor

There are two (2) sets of monaural audio connectors
(Figure 1, Item 8); one for audio input and one
for a loop-through output to another device.
In
Out
NOTE: AUDIO A is associated with VIDEO A; and
AUDIO B with both VIDEO B & VIDEO Y/C.
EN | 10
Y/C (In)
Y/C (Out)