BlueTrek G2 User Manual page 6

2. Pairing Bluetrek
Before using the Bluetrek
ing is the process of linking 2 Bluetooth
The pairing only needs to be done once. Afterwards, every time you switch on your headset, it will
automatically connect to your mobile phone. If you pair your Bluetooth
Bluetooth ® device, you will have to pair the Bluetrek
The profile (Headset or Hands-Free) is automatically selected by the Mobile phone during the
Pairing stage.
IMPORTANT : Before pairing, all Bluetooth
To initiate the pairing, put both the headset and the mobile phone within 0.3 meter (1 foot) from
each other. Make sure there is no Wi-Fi equipment operating in the vicinity.
1. Switch on your phone and select the Bluetooth
®
the Bluetooth mobile phone user guide).
2. Press and hold (do not release it) the TALK button for about 7 seconds until the indicator light
flashes red and blue alternatively. Then release the TALK Button. A beep can be heard in the
speaker.
3. Once the mobile phone detects the headset, a message is displayed with the following infor
mation : "Bluetrek g2".
4. Follow the phone instructions to accept the pairing. The PIN code (or passkey) is 0000.
5. When the pairing is completed, the indicator light will switch to blue, and flashes slowly.
If you haven't started the discovery mode within 5 minutes, the headset will switch off.
You must then switch on your headset and start the pairing again.
A very limited number of Bluetooth mobile phones require a different pairing process
that the one explained above. If you encounter any difficulties to pair your headset with your
mobile phone, visit our website www.bluetrek.com or consult your dealer.
®
G2
® G2 headset, you must pair it with your Bluetooth
®
devices, so that they can communicate.
®
devices must be switched off.
®
mobile phone with another
® G2 with your phone again before use.
®
discover mode on the Mobile phone (See
® mobile phone. Pair-
Bluetrek G2 user guide l 6