Charging - BlueTrek E2 User Manual

Charging the BLUETREK
Please connect the charger to the headset and to the main. During the charge, the
indicator light is red. The indicator light will turn off when the charge is complete. During
subsequent charges, the charging should take approximately 3 hours.
When you hear a low-tone beep in your headset at regular intervals, and the indicator
light flashes in red, your headset needs to be recharged.
Important:
• If your headset is fully charged, the red indicator light will not turn on when
plugging into the charger.
(To check whether your headset is fully charged, press the talk button for approx.
2 seconds, once released, the red indicator light will turn on for approx. 3
seconds.)
• To maximize battery lifetime, it is recommended to recharge your headset to full
capacity only when the battery is low, since a battery has a lifetime of about 500
charging cycles.
• If you leave your headset battery empty for an extended period of time, it could
excessively discharge the battery. In this case, charge your headset for 3 hours
or more until the battery recovers and recharges completely. When you first
charge the headset after prolonged storage, it may take few minutes for the red
indicator light to turn on.
• Do not charge your headset for more than 10 hours.
• The use of any other charger will automatically suspend the warranty. It is strictly
forbidden and can be very dangerous.
Pairing the BLUETREK
Before using the BLUETREK
phone. Pairing is the process of linking 2 Bluetooth
communicate.
To initiate pairing:
1. Place the BLUETREK
each other.
2. Switch on your phone and select its Bluetooth
®
Bluetooth mobile phone user manual).
3. When the BLUETREK
about 7 seconds until the indicator light flashes red and blue alternately. And a
sound can be heard in the speaker.
4. Once the mobile phone detects the headset, a "BLUETREK E2" message will be
displayed. Follow the phone instructions to accept the pairing. The PIN code (or
passkey) is 0000, then press "yes" or "ok".
If pairing was successful, the indicator light will switch to blue and flashes slowly.
If you haven't started the discovery mode within 5 minutes, the headset will switch off.
You must then switch on your headset and start the pairing again.
®
E2
®
E2
®
E2 headset, you must pair it with your Bluetooth
®
E2 and your mobile phone within 0.3 meter (1 foot) from
®
E2 is switched off, press and hold the TALK button for
PAGE 3 / 6
®
devices, so that they can
®
discover mode (refer to the
®
mobile