Complete The Installation - Kohler K-1107 Installation Manual

Finished
Deck
Material
Bath

7. Complete the Installation

Carefully remove the protective tape from the bath rim.
Cover the framing with water-resistant wall material.
Seal the joints between the bath rim edges and the water-resistant wall material with silicone
sealant. Tape and mud the water-resistant wall material.
Install the finished wall. Seal the joints between the bath rim and the finished wall with silicone
sealant.
Install the faucet trim according to the faucet manufacturer's instructions.
Clean-Up Procedures
CAUTION: Risk of product damage. Do not allow cleaners containing petroleum distillates to remain
in contact with the surface for long periods of time.
CAUTION: Risk of product damage. Do not use abrasive cleaners, as they may scratch and dull the
bath surface. Use warm water and a liquid, non-abrasive detergent to clean the surface.
CAUTION: Risk of product damage. Do not use metal scrapers, wire brushes, or other metal tools to
remove stains, paint, plaster, or tar. Use turpentine or paint thinner to remove stains, paint, or tar. Use
a powder-type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
Clean and rinse the bath completely with water immediately after applying cleaners. Rinse and dry
any overspray that lands on nearby surfaces.
Kohler Co.
Apply silicone
sealant to the edges
of the water-resistant
deck material and
the finished deck.
Water-Resistant
Deck Material
Framing
1/16" (2 mm)
Gap
Bath
7
Finished Wall Material
Water-Resistant
Wall Material
Silicone Sealant
Tiling-In Bead
2x4 Studding
Ledger Strip
1023730-2-F