Brother FAX-8350P Owner's Manual page 151

DIFFICULTY
My headers or footers
appear when I view my
document on the screen but leaves 62 printable lines. Adjust the top and bottom margins
do not show up when I
print them.
®
Windows
I cannot print from my
Setup Printing
application software.
Difficulties
(For MFC-9650/
FAX-8750P only)
DOS Setup
I cannot print from my
Printing
application software.
Difficulties
(For MFC-9650/
FAX-8750P only)
The machine prints, but it
prints incorrect information. setting and the machine's printer emulation do not match.
Sometimes it prints a
couple of characters and
then ejects the page, etc.
Paper
The machine does not load Check to see if the CHECK PAPER or PRINTER JAM
Handling
paper.
Difficulties
The machine does not load Reinsert the paper firmly, one sheet at a time.
paper from the manual
feed slot.
How can I clear paper
jams?
Copy Quality Vertical streaks appear in
Difficulties
copies
Printouts are too dark or
Print Quality
Difficulties light
T R O U B L E S H O O T I N G A N D M A I N T E N A N C E
SUGGESTIONS
Most laser printers have a restriced area that will not accept
print. Usually these are the first two lines and last two lines,
in your document to allow for this.
Make sure the Windows
select it in your application software.
Check that the DOS application software interface settings
match those of your printer: for example, if you are using a
parallel printer cable, you would probably set your DOS
software printer port to LPT1. Check for an error message
on the LCD.
This is an indication that your application printer emulation
Check your application software to make sure you selected
the correct printer driver.
message appears on the LCD. If so, the paper cassette may
be out of paper or not properly installed. If it is empty,
load a new stack of paper into the cassette. If there is paper
in the paper cassette, make sure it is straight. If the paper is
curled, you should straighten it. Sometimes it is helpful to
remove the paper, turn the stack over and put it back into
the paper cassette. Reduce the amount of paper in the paper
cassette, then try again. Check the manual feed mode is not
selected in the printer driver (MFC-9650/FAX-8750P).
Make sure that manual feed mode is selected in the printer
driver (MFC-9650/FAX-8750P).
See "Printer Jams".
Sometimes you may see vertical streaks on your copies.
Either the scanner or the primary corona wire for printing is
dirty. Clean them both.
Adjust the print conditions by setting the Print Density
function, It has been factory set to the middle position. See
"Setting the Print Density" in chap. 5.
®
printer driver is installed and you
141