Advertisement
15. Remove right screw from blower assembly (see
Figure 3). Do NOT discard screw as it will be re-
installed.
16. Install panel switch bracket directly behind blower
mounting angle where screw was removed (see
Figure 3). Align bottom hole in bracket with hole
where screw was removed in Step 13.
17. Re-install screw to secure blower assembly and
panel switch assembly.
ROUTE WIRES THROUGH
BUSHING
FILTER PARTITION
BUSHING
Manual 7960-912
Page
6 of 8
FIGURE 4
Panel Switch Wire Routing
BLOWER PARTITION
UPPER CONTROL
FILTER SLIDE
PANEL BUSHING
18. Remove left filter and filter slide, then route long
orange wire from relay assembly (up to door panel
switch) and connect to "NO". Route wire from
door panel switch (down to control panel) through
upper right control panel bushing, through filter
partition housing and blower partition as shown in
Figure 4.
19. Seat spade end of orange wire from panel switch
assembly under the "G" terminal on low voltage
strip assembly, then seat spade end of black/white
wire from coil on relay assembly under the "C"
terminal on low voltage strip (see Figure 5).
MIS-4314
Advertisement
