Nokia RH-37 Series Rf Troubleshooting Instructions page 25

Nokia Customer Care
The setup should now look like this:
Now the measurement equipment should detect the following output signal of the
phone:
P = +23dBm @ 1747.8 MHz
out
If this is not the case, then go to the GMSK fault finding chart for GSM1800 transmitter.
EDGE
Set operating mode to local mode.
Select
Wait until the RF controls window pops up.
Select
Issue 1 07/04
Testing
Band
Active unit
Operation mode
RX/TX Channel
TX Power Level
Nokia Corporation
6(b) - RF Troubleshooting Instructions
RF Controls
GSM 1800
TX
Burst
700
5
RH-37
Page 25