Nokia 3806 Service Manual page 73

RM-583
Service Software Instruction
VBat=0
CalCell=1
CalPCS=0
GPSTest=0
Note: 0: indicates "Not Select"; 1: indicates "Select".
4. Turn on device
Make sure that which com port is used, and connect all kinds of cable shown as "Hardware Connection",
configure sysconfig.ini and calibrationconfig.ini according to the introduction above;
5. Start Test
Click "Start" Button, pop up input dialog and input device serial number, shown as below
After input serial number, Press "Enter" key to begin to calibrate, shown as below:
Issue 1
COMPANY CONFIDENTIAL
Copyright © 2009 Nokia. All rights reserved.
Page 3-45