Brother DCP-310CN User Manual page 66

DIFFICULTY
Software Difficulties
Cannot install software or print
'Device Busy'
™
PhotoCapture Center
Removable Disk does not
work properly.
Cannot access Removable
Disk from Desktop icon.
Network Difficulties (DCP-310CN only)
I cannot print over the network
Other Difficulties
Incorrect LCD language
SUGGESTIONS
Run the Repair MFL-Pro Suite program on the CD-ROM. This program
will repair and reinstall the software.
Make sure the DCP is not showing an error message on the LCD.
Difficulties
a) Have you installed the Windows
If not, do the following:
1. Disconnect the USB cable.
2. Install the Windows
Guide. After the installation the PC will be automatically restarted.
3. Wait about 1 minute after you reboot the PC, and then connect the
USB cable.
b) Take out the media card and put it back in again.
c) If you have tried "Eject" from within Windows
media card before you continue.
d) If an error message appears when you try to eject the media card, it
means the card is being accessed.
Wait a while and then try again.
e) If all of the above do not work, please turn off your PC and DCP, and
then turn them on again.
(You will have to unplug the power cord of the DCP to turn it off.)
Make sure you have inseted the media card into the media slot.
Make sure that your DCP is powered on and is On Line and in Ready
mode. Print Network Configuration list. (See Printing reports on page
A-1.) Then the current settings of the network are printed. Reconnect
the LAN cable to the hub to verify that the cabling and network
connections are good. If possible, try connecting the DCP to a different
port on your hub using a different cable. If you have good connections,
the machine will show LAN Active for 2 seconds.
See How to change LCD language on page 5-9.
TROUBLESHOOTING AND ROUTINE MAINTENANCE 5 - 8
®
2000 update?
®
2000 update. Please see the Quick Setup
®
, you must take out the