Wiring; Adding The Device - Danfoss Link DBR Installation Manual

Installation Guide

Wiring

Danfoss Link™ DBR
Electronics
N L
230 V AC
Note: Refer to boiler manufacturer's manual for wiring connections
to the boiler.

Adding the device

The process of adding the Danfoss Link™ DBR
to a system is performed on the Danfoss
Link™ CC.
Note that the Danfoss Link™ DBR
must be added as a Service
Device.
When adding, press and
release the install button,
and observe that the LED
gives a fast green flash.
If adding is successful the LED turns green permanently.
For further information, see the Danfoss Link™ CC instruction
manual.
Note: If adding the Danfoss Link™ DBR to the Danfoss Link™ CC is
unsuccessful, make sure the right Danfoss Link™ CC software
version is applied. Correct version: 4.1.0 or higher.
VIIOS202
Danfoss Link™ DBR
1 2 3 4
ESM-11
© Danfoss 07/2017
Remove
jumper
if fitted
T
T
Boiler ON/OFF
terminals
UK
UK
NL
FR
7