Connecting The Mask; Example Of A Fully-Assembled System - ResMed VS III User Manual

Once your circuit is connected to the device, you can connect the mask
to the other end of the circuit.
Note: These three circuit configurations may not be exactly as shown in
this illustration. It may also include a humidification system, antibacterial
filter or water traps. Contact your HME provider if you have any
questions about connecting your respiratory circuit.

3.3 Connecting the mask

Refer to the instructions given by your physician or HME provider.
CAUTION
It is essential to use only the mask supplied by your physician or
HME provider.

3.4 Example of a fully-assembled system

Figure 11: Example of a fully-assembled system (single circuit with valve
and pressure line)
If your setup does not have any accessories (oxygen accessories,
external battery or remote alarm), you can now switch your device on
(see next paragraph).
P P
Connection procedures 11