Toshiba RAV-SM2244DTP-E Owner's Manual page 40

3
1
2
5
6
7
16
11
UNIT No. display
The selected indoor unit number is displayed.
Also number of indoor or outdoor unit which a
problem occurs is displayed.
12
Central control display
Displayed when the air conditioner is used under
the central control in combination with a central
control remote controller.
In case the remote controller is disabled by the
central control system, flashes. The button
operation is not accepted.
Even when ON / OFF, MODE, or TEMP.
button is pushed, and the button operation is
not accepted. (Settings made by the remote
controller vary with the central control mode.
For details, refer to the Owner's Manual of the
central control remote controller.)
75-EN
1117880601_EN.indd 39 1117880601_EN.indd 39
11
12
4 10
9
13
8 14
15
13
Remote controller sensor display
Displayed while the sensor of the remote
controller is used.
14
Pre-heat display
Displayed when the heating mode is energized
or defrost cycle is initiated.
While this icon is displayed, the indoor fan stops.
15
No function display
Displayed when the function requested is not
available on that model.
16
Service display
17
Operation ready display
This display appears on some models.
– 39 –
■
Operation section
Push each button to select a desired operation.
• The control saves commands in memory and after the initial setting, there is no need for any additional settings
unless changes are desired. The air conditioner can be operated by pushing the
1
2
17
3
4
1
button (Temperature set button)
Adjusts the set point.
Select the desired set point by pushing TEMP.
or TEMP. .
2
button (Timer set button)
Use to setup the timer.
3
button (Filter reset button)
Resets " " display after cleaning filter.
4
button (Test button)
Use only for service.
(During normal operation, do not use this
button.)
5
button
When the button is pushed, the operation starts,
and it stops by pushing the button again.
When the operation has stopped, the operation
lamp and all the displays disappear.
6
Operation lamp
Green light illuminates when unit is on.
Although it flashes when operating the
protection device or a problem occurs.
7
button (Operation mode button)
Selects desired operation mode.
8
button (Fan speed button)
Fan speed is not adjustable.
9
button (Ventilation button)
Use when a power ventilation kit (locally
procured) is connected.
• If " " is displayed on the remote controller
when this button is pushed, no vent kit
connected.
button.
5
6
7
8
9
10
11
12
10
button (Power save operation)
Use to initiate power saving mode.
11
button (Unit / Louver select button)
Selects a unit number (left) and louver number
(right).
UNIT:
Selects an indoor unit when multiple indoor units
are controlled with one remote controller.
LOUVER:
No Function.
12
button (Swing / Louver direction
button)
No Function.
OPTION:
Remote controller sensor
Usually the temperature sensor of the indoor unit
senses the temperature. The temperature on the
surrounding of the remote controller can also be
sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
76-EN
3/15/2559 BE 08:50 3/15/2559 BE 08:50