Rear Panel Features; Lcd Features - Numark NDX400 Quick Start Manual

REAR PANEL FEATURES

1. VOLTAGE SELECTOR -- - Set this switch to
the voltage for your location.
2. POWER PLUG CONNECTOR – Plug your
supplied power cord in here.
3. POWER SWITCH – Turn the machine on
and off with this button.
always be shut down with this button first
before any external power is removed.
Typically it is recommended that the CD
player is powered on before amplifiers and
powered off after amplifiers.
4. RCA AUDIO CONNECTORS – Connect your CD player to your mixer from this line level output.
5. REMOTE START CONNECTOR – To use this connector for fader start, connect a fader start cable
(not included) to a fader start-compatible mixer. Every time you move the crossfader on the mixer over
to the side that the unit is on, it will automatically start playing. When you move the fader away from
that side, the unit will stop. Moving the fader back to the unit side will start play again.

LCD FEATURES

1. PLAY / PAUSE – This shows when the
unit is playing or paused.
2. CUE – Lit continuously when the unit is
paused at a cue point.
3. CD / USB – Indicates whether you are
playing tracks from a loaded CD or a
connected USB device.
4. TRACK / FOLDER NUMBER – Shows
the current track or folder number. When viewing or playing a program, the number will have a "P" in
front of it ("P01," "P02," etc.), indicating the number of that track in the program.
5. TOTAL TRACK – Displays the total number of tracks available on the CD or USB device. (When in
Folder View, it will display the total number of folders available on the USB device.)
6. MINUTES – Shows the minutes elapsed or remaining depending on mode setting.
7. SECONDS – Shows the seconds elapsed or remaining depending on mode setting.
8. FRAMES – The CD player breaks down a second into 75 frames for accurate cueing. This shows the
frames elapsed or remaining depending on mode setting.
9. TIME MODE – Indicates whether the time shown on the LCD is the elapsed time for the track,
remaining time for the track, or total remaining time for the entire CD.
10. TIME BAR – Shows either time remaining or elapsed depending on the setting of the TIME button.
11. PLAY MODE – Shows when the unit is set to Auto-Cue Mode (the deck will stop at the end of each
track) or Continuous Play Mode (the entire disc will be played without interruption). This function is
controlled by the SINGLE button.
12. RELOOP – Indicates when a loop is programmed.
13. BPM – Displays the tempo in BPM (beats per minute) of the current track. When "AUTO BPM" is
displayed, it is a tempo that has been automatically detected.
14. PITCH – Shows the percentage change in pitch.
15. MT (MASTER TEMPO) – Indicates that the MASTER TEMPO button is engaged.
16. PROG – Indicates that a program is playing.
17. TEXT DISPLAY – Displays the folder name or file name when navigating MP3s.
The unit should
5
1
2
3
6
4
5
11 9 10
4 17
6 7
2
3
1
14
15
12
13
8 16