Table of Contents
Advertisement
REAR PANEL FEATURES
1.
CONTROL CABLE CONNECTOR – Plug in the 8-pin cable included in here to connect the remote control and main CD
unit together
2.
POWER PLUG CONNECTOR – Plug your supplied power cord in here.
3.
VOLTAGE SELECTOR – Set this switch to the voltage for your location.
4.
RCA AUDIO CONNECTORS – Connect your CD player to your mixer from this line level output.
5.
DIGITAL OUTPUT – The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In
order to use the digital output you should not use variable pitch slider and the pitch bend buttons. If you adjust the pitch,
other devices may not read the digital output properly because the sampling rate changes
6.
AUTO-START CONNECTORS – Use this connector to plug into your Fader Start-compatible mixer.
CD PLAYER FEATURES
1.
OPEN/CLOSE
(Disc
Tray Open/Close) –
Press to load or eject
the disc. Each press
will open or close the
disc
tray
on
the
transport.
NOTE:
Tray will not
open unless the disc
has
been
paused.
Tray will automatically
close
after
30
seconds.
2.
TIME (Time Button) –
Switches
the
time
display
between
elapsed playing time
and remaining time on
the
track
and
remaining time on the
entire CD.
3.
CONT/SING – Will cause just a single track to play or all tracks in order by pressing once or twice.
4.
LCD DISPLAY – Indicates all the functions, as they are occurring, with the CD. These functions are explained in the
next section.
5.
TRACK (Track Buttons) – Used to select the track to be played.
6.
Folder/+10 Button – Steps up or down through folders on MP3 discs. On a disc which contains no folders, this button
advances the track by 10.
7.
PROGRAM – Depress this button and the unit will stop and the program indicator will light. Select each track to be
programmed and press the PROGRAM button between selections. You can program up to 20 tracks. Press PLAY to
start the program. To exit and erase program, either hold the program button down for more than 2 seconds while the
unit is stopped, open the disc tray, or turn off the power.
8.
PITCH (Pitch Button) – Activates the Pitch Slider. To alternate between ±8% and ±16%, press and hold the PITCH
button. The LED will indicate the pitch setting.
9.
PITCH SLIDER – The pitch can be changed up to ±16% by pressing the PITCH button so the PITCH LED is lit, then
moving the sliding fader. The pitch will not be changed if the PITCH LED is off.
10.
SEARCH WHEEL (OUTER RING) – 3 forward and 3 reverse speed positions for searching through songs. The more
you turn the wheel in either direction the faster you search through the music.
5
2
3
4
4
1
6
6
1
5
4
Advertisement
Table of Contents
