Table of Contents
Advertisement
Opening the door after the programme has started
First set the machine to pause by pressing the button 8.
If the messages «Pause» and «Door unlocked» appear alternately on the
●
display, the door can be opened.
the messages «Pause» and «Door unlocked» don't appear on the display,
If
●
this means that the machine is already heating, that the water level is above
the bottom edge of the door or that the drum is turning: in this case the
door can not be opened.
If you cannot open the door but you need to open it you have to switch the
●
machine off by turning the selector dial to
can be opened (pay attention to the water level and temperature!). To
restart the programme again, turn the selector dial on the previous
programme and press the button 8.
At the end of the programme
The machine stops automatically. The pilot light of the button 8 goes off, a
0.00
flashing
minutes.
If the Rinse Hold or Night Cycle option has been selected, the pilot light of the
button 8 goes off, the messages «Door locked» and «Rinse hold» appear on the
display, the door is blocked to indicate that the water must be emptied out.
Please follow the below instructions to empty out the water:
turn the programme selector dial to
●
select the DRAIN or SPIN programme
●
reduce the spin speed if needed, by means of the relevant button
●
press the button 8
●
when the programme has finished the display shows a flashing
●
message «Finished». The door can be opened.
Turn the programme selector dial to
the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
appear on the display and the acoustic signal sounds for some
. After about 3 minutes the door
O
O/OFF
O/OFF
to switch the machine off. Remove
Use
23
0
and the
Advertisement
Table of Contents
