Table 1-5 Components On The Profinet - Siemens SIMOTION D45 Series Manual

Description
1.2 System components
PROFINET
The use of a Communication Board Ethernet (CBE30) enables SIMOTION D4x5 to
communicate with the following components via PROFINET:
Table 1-5
Component
Programming device (PG/PC)
Master computer
SIMATIC HMI device
SIMATIC ET 200S
SIMATIC ET 200pro
Drive units with PROFINET
interface
Other controllers (e.g.
SIMOTION or SIMATIC)
Gateways
DRIVE-CLiQ
The DRIVE-CLiQ interfaces permit a fast connection to the SINAMICS drive components.
DRIVE-CLiQ offers the following advantages within the DRIVE-CLiQ topology rules:
• Independent expansion of components possible
• Automatic detection of components by the control unit
• Standardized interfaces to all components
• Uniform diagnostics down to the components
• Complete service down to the components
• Simple mechanical handling
16
Components on the PROFINET
Function
... communicates with the "SIMOTION SCOUT", STEP 7, and HMI
(Human Machine Interface) engineering systems (ES).
... communicates with other devices via UDP, TCP/IP.
... is used for operator control and monitoring functions. This is not
an essential requirement for the operation of a SIMOTION D4x5.
Finely modular I/O system for control cabinet installation including
motor starters, safety technology, and individual grouping of the
load groups.
Modular I/O system with IP65/66/67 degree of protection for
cabinet-free use close to the machine; with new features such as
smaller frame size, integrated PROFIsafe safety technology,
PROFINET connection, and hot swapping of modules.
... convert speed setpoints into signals for controlling the motor
and supply the power required to operate the motors.
IE/AS-Interface link PN IO for the PROFINET IO gateway to
•
AS-Interface
PN/PN coupler for connecting two PROFINET IO networks
•
IE/PB link PN IO for the PROFINET IO gateway to
•
PROFIBUS DP
D4x5
Manual, 03/2007 Edition