Introduction To Rf Troubleshooting; Rf Key Component Placement - Nokia E62 Service Manual

RM-88
RF Troubleshooting and Manual Tuning Guide

Introduction to RF troubleshooting

All measurements should be done using:
• spectrum analyser with a high-frequency high-impedance passive probe (LO-/reference frequencies and
RF power levels)
• oscilloscope with a 10:1 probe (DC-voltages and low frequency signals)
The RF section of the phone is around RF ASIC N7505, TX FEM N7520, and all of this RF section is built inside
of non-removable shields A7506, A7507. Therefore, the engine will be replaced after carefully checked power
and receiver tuning at antenna port.

RF key component placement

Issue 1 COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
Nokia Customer Care
Page 7 –5