Installing Flash Support Files For Fps-10 - Nokia E62 Service Manual

RM-88
Service Software Instructions
iv For a plain USB connection, choose the following connection settings:
Note: First connect the DKE-2 USB cable between the PC USB port and phone.
• Media: USB
5. To complete the configuration, click Finish.
6. Click the connection you want to activate. Use the up/down arrows located on the right hand side to move
it on top of the list, then click Apply.
The connection is activated, and it can be used after closing the
The connection information is shown at the right hand bottom corner of the screen.
7. To use the connection, connect the phone to your PC with correct service tools. Make sure the phone is
switched on, and then choose File→Scan Product .
Results
The product support module information appears in the status bar:

Installing flash support files for FPS-10

Prerequisites
Note: You need to install flash support files for FPS-10 only, if you don't have the latest Phoenix
available or the flash support files have changed after the latest Phoenix release.
• Flash support files are installed automatically, when you install Phoenix. Use Phoenix packages later than
June 2006.
• Normally it is enough to install Phoenix and the phone-specific data package because the Phoenix
installation always includes the latest flash update package files for FPS-10.
• A separate installation package for flash support files is available, and the files can be updated according
to this instruction, if updates appear between new Phoenix / data package releases
Context
If you are not using a separate installation package, you can skip this section and continue with
Unable to generate link title]]]
Issue 1
Figure 18 Connections list
Figure 19 Connection information
Figure 20 Product support module information (example from RM-1)
(page ) after installing a new phone data package.
COMPANY CONFIDENTIAL
Copyright © 2006 Nokia. All rights reserved.
Nokia Customer Care
Manage Connection window.
[[[ERROR:
Page 3 –19