Yamaha Aerox GDR155 Owner's Manual page 46

Instrument and control functions
To reset both the tripmeter and the in-
dicator, select the V-belt replacement
tripmeter, and then push the "MENU"
switch until "V-BELT" and the tripme-
ter start flashing. While "V-BELT" and
the tripmeter are flashing, push the
"MENU" switch until the tripmeter is
reset.
TIP
When the V-belt is replaced, the trip-
meter and indicator must be reset.
Otherwise, the V-belt replacement in-
dicator will not come on at the correct
7
time.
Instantaneous fuel
display
1
1. Instantaneous fuel consumption display
This display shows fuel consumption
under current riding conditions. It can
be set to either "km/L" or "L/100 km".
 "km/L": the distance that can be
traveled on 1.0 L of fuel.
 "L/100 km": the amount of fuel
necessary to travel 100 km.
TIP
When traveling under 10 km/h, "_ _._"
is displayed.
Average fuel consumption display
EAUV1030
consumption
1. Average fuel consumption display
This display shows the average fuel
consumption since it was last reset.
The average fuel consumption display
can be set to either "km/L" or "L/100
km".
 "km/L": the average distance that
 "L/100 km": the average amount
TIP
 To reset the display, push the
 After resetting, "_ _._" is shown
EAUV1040
Battery voltage display
1
1. Battery voltage meter
This display shows the current charge
state of the battery.
 Over 12.8 V = Full charge.
 Under 12.7 V = Charging is re-
7-10
can be traveled on 1.0 L of fuel.
of fuel necessary to travel 100 km.
"MENU" switch until it resets.
until the vehicle has traveled some
distance.
quired.
EAU86960