Maintenance Procedures; Safety Cable; Coupler; Tires - BRP SEA-DOO ADVANCED TEC 2010 User Manual

MAINTENANCE PROCEDURES

This section includes instructions for
basic maintenance procedures. If you
have the necessary mechanical skills
and the required tools, you can per-
form these procedures. If not, see
your authorized Sea-Doo personal wa-
tercraft (PWC) dealer.
WARNING
Torque wrench tightening speci-
fications must be strictly adhered
to.
Locking devices, when removed
(e.g.: locking tabs, elastic stop
nuts, cotter pins, etc.), must be
replaced.
Hoses, cables or locking ties removed
during a procedure must be reinstalled
as per factory standards.

Safety Cable

Safety Cable Inspection
Inspect cable for damage.
If cable or its liner are damaged, stop
using the trailer and contact a Sea-Doo
authorized dealer.
WARNING
Do not use the trailer if safety cable
is damaged.

Coupler

Coupler Inspection and Lubrication
Check locking mechanism operation.
Check ball socket, ball clamp and lock
mechanism for wear or damage.
Apply a thin coat of multipurpose
grease to the inner surface of the ball
socket.
Apply light oil to the pivot and sliding
surface of the lock mechanism.
https://www.boat-manuals.com/

Tires

Tire Pressure
Check tires pressure. Tire pressure
must be checked while the tire is cold.
NOTE: Do not check the tire pressure
immediately after towing the trailer.
Allow at least three hours for a tire to
cool down, if the trailer has been towed
for as much as 1.6 km.
COLD TIRE
Tire Inspection
Replace the tire before towing the
trailer if the tire tread has less than
1.6 mm depth or if the built-in wear in-
dicator bars are visible and flush with
the remainder of the tire tread.
Always replace a tire with one of the
same dimensions and load limit.
Inspect both sidewalls of each tire for
any bubble, cut or bulge; and replace a
damaged tire before towing the trailer.
A bubble, cut or bulge in the side-
wall can result in a tire blowout and
loss of control.

Wheels

Wheel Inspection
Check wheel for cracks, bumps or
other damages. Replace wheel as
required.

Wheel Bearings and Seals

Wheel Bearing Inspection
Install a jack under the axle and raise
until the tire gets off the ground.
Push and pull the wheel from the upper
edge to feel the play and rotate wheel.
_______________
TIRE PRESSURE
351 kPa
WARNING
37