Fitting The Trailer To The Watercraft (Advanced Tec) - BRP SEA-DOO ADVANCED TEC 2010 User Manual

MODEL NAME
RXT™, RXT™-X™ with S
Limited, Wake Pro 215
RXT™ iS, GTX
RXT™, GTX † , GTX
(except S
GTI™, GTI™ SE, Wake 155
To adjust, loosen the iCatch support
bolts, move support to the desired po-
sition, then tighten nuts as follows:
1. Progressively tighten nuts in a
crisscross pattern until support is
square with the trailer tongue.
2. Tighten to 8 N•m ± 1 N•m.
Fitting the Trailer to the
Watercraft (ADVANCED
TEC)
Set tongue weight, bow stopper roller,
and bunks as follows.
Tongue Weight
Move winch support towards front or
rear of trailer in order to adjust tongue
weight.
The tongue weight should be from 3
to 10% of the total trailer and PWC
weight with tongue parallel to the
ground.
To adjust, loosen the 4 nuts under-
neath the winch support u-bolts, move
winch support to the desired position,
then tighten nuts to 27 N•m ± 3 N•m.
TONGUE MEASUREMENT GUIDELINE
3 hull™, GTX
† iS™, GTX † Limited iS™
† Wake™, RXT™-X™
3 hull™)
RXP™
RXP™-X™
https://www.boat-manuals.com/
MODEL YEAR
†
2009-2010
2002 through 2009
2006 through 2010
2004 through 2010
2008 through 2010
smo2010-003-025_a
1. Winch support u-bolts nuts
Bow Stopper Roller
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet.
To adjust:
1. Loosen the 2 nuts underneath the
front winch support u-bolt.
2. Remove the winch arm adjustment
bolt.
3. Set the bow roller stopper to the de-
sired height, then lock it in position
by inserting the bolt through the
aligned winch support and winch
arm holes.
_______________
2010
TRAILER SET-UP
TONGUE
DISTANCE
40.6 cm
33 cm
28 cm
30.5 cm
17