Launching The Watercraft; Launching The Watercraft (Advanced Tec Icatch) - BRP SEA-DOO ADVANCED TEC 2010 User Manual

LAUNCHING THE WATERCRAFT

Launching the Watercraft
(ADVANCED TEC iCatch)
NOTICE
Taillights are not sub-
mersible, before launching or load-
ing, always remove taillights.
1. Prepare the personal watercraft
(PWC) for launching according to
the PWC manufacturer's recom-
mendations.
2. Remove tie-downs from stern and
trailer eyelets.
3. Remove safety cable from bow cup.
4. Disconnect taillight connector as
follows:
4.1 Rotate
clockwise.
4.2 Pull connector out of the
mounting plate.
smo2010-004-400_a
5. Unscrew both locking devices.
smo2010-004-401_a
1. Locking devices
connector counter-
https://www.boat-manuals.com/
6. Remove taillight from trailer by
pulling it upwards.
smo2010-004-402_a
7. Carry out same steps for removing
the other taillight.
8. Make sure the way is clear behind
the trailer (in and out of water).
CAUTION The watercraft can
easily travel 10 m on the water once
launched from the trailer.
9. Have someone guiding you and
back the vehicle until water level
is within the water level decal upper
and lower edges.
smo2010-003-029_a
WATER LEVEL DECAL
NOTE: On very gentle slopes, water
level may go over the decal zone, how-
ever, the PWC must not float above
the rollers.
_______________
23