Loading The Watercraft; Loading The Watercraft (Advanced Tec Icatch) - BRP SEA-DOO ADVANCED TEC 2010 User Manual

LOADING THE WATERCRAFT

Loading the Watercraft
(ADVANCED TEC iCatch)
NOTICE
Taillights are not sub-
mersible, before launching or load-
ing, always remove taillights.
1. Disconnect taillights connector.
2. Remove taillights from trailer, refer
LAUNCHING THE WATERCRAFT
to
in this subsection for the procedure.
3. Make sure the iCatch system is un-
locked and the release handle is UP.
smo2010-005-004
UNLOCKED (HORIZONTAL)
smo2010-003-010
HANDLE UP
WARNING
Always make sure the iCatch sys-
tem is unlocked before loading the
watercraft.
4. Have someone guiding you and
back the vehicle until water level
is within the water level decal upper
and lower edges.
______________
26
https://www.boat-manuals.com/
smo2010-003-029_a
WATER LEVEL DECAL
NOTE: On very gentle slopes, water
level may go over the decal zone, how-
ever, the PWC must not float above
the rollers when watercraft contacts
the iCatch mechanism.
5. Take place on the watercraft.
6. Put your personal flotation device
(PFD) on and attach the safety lan-
yard to it.
7. Start engine and steer watercraft at
idle speed to align it with the trailer
rollers.
WARNING
Make sure nobody stands on the
walk pads when loading the water-
craft.
8. At idle, make contact between the
watercraft bow with the iCatch
mechanism. It may be necessary
to slightly depress throttle lever for
this operation.
NOTICE
Rocks, sand or other de-
bris will be sucked into the water-
craft propulsion system if engine is
operated using too much throttle in
shallow water.
NOTE: Make sure that the iCatch han-
dle has returned in the closed position
(DOWN).