Troubleshooting - Haier HWD8040BW1 User Manual

Troubleshooting

In case of power failure
The current programme and its setting will be saved.
When power supply is restored, operation will be
resumed.
If a power failure cuts an operating wash programme，
door opening is mechanically blocked. To get out any
laundry，water level should not be seen in the glassy
porthole of the door. Danger of burns! Water level has
to be lowered as described in "Pump filter". Not till then
pull level(A) beneath service flap until door as unlocked
by a gentle click. Afterwards refix all parts.
Troubleshooting without display code
Problem Cause
1. Power failure
Washing machine
2. Machine hasn't been switched
fails to operate
on.
3. Door is not properly closed.
4. Programme is not
1. No water inlet.
Washing machine
2. Inlet hose is kinked.
will not fill with
3. Inlet hose filter is blocked.
water.
4. Water pressure is less than
0.03MPa.
5. Door is not properly closed.
6. Water supply failure.
1. Height of drain hose is bel ow
Machine is
80cm.
draining while
2. Drain hose end is submerged
being filled.
in water?
1. Drain hose is bloc ked.
Drainage failure.
2. Pump filter is blocked.
3. Drain hose end is higher than
100cm above floor level.
Solution
1. Check power supply.
2. Switch the machine on.
3. Close the door properly.
4. Touch " Start /Pause"
started yet. button.
1. Check water tap.
2. Check inlet hose .
3. Unblock inlet hose filter.
4. Check water pressure.
5. Close the door properly.
6. Ensure the water supply.
1. Make sure that drain hose is
properly installed.
2. Make sure the drain hose is
not in water.
1. Unblock drain hose.
2. Clean pump filter.
3. Make sure that drain hose is
properly installed.
24 25
Problem
Strong vibration
while spinning.
Operation stops
for a period of
time.
Operation stops
before completi-
ng wash cycle.
Excessive foam
floats drum and/or
detergent drawer.
Automatic adjust-
ment of washing
time
Spinning fails
General information and tips:
If too much foam is visible during spin cycle, the motor will stop and drain
pump will activate for 90 seconds. If that elimination of foam fails up to 3
times, programme ends without spinning.
Cause Solution
1. Not all transportation bolts 1. Remove all transportation
have been removed.
2. Applian ce has no solid 2. Ensure solid ground and
position.
3. Machine load is not balanced. 3. Check load weight and
1. Appliance displays error code. 1. Consider displ ay codes.
2. Problem due to load pattern. 2. Reduce or adjust load.
3. Cancel programme and
Check power and water
Water or electric failure.
supply.
1. Detergent is not a appropriate. 1. Check detergent recom-
2. Excessive use of detergent in
manually dosag e. 2. Reduce amount of dete-
Washing programme
This is normal and doesn't
duration will be adjusted. affect functionality.
Unbalance of laundry. Check machine load.Run the
Spin programme again.
Troubleshooting
bolts.
a levelled position.
balance.
restart.
mendations.
rgent.