9- Troubleshooting - Haier HWD80-BP14636 User Manual

9- Troubleshooting

GB
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages..
A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes
6:30 The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes
End
Function child lock is activated
cLo1-
Door is closed because of high water level, high water temperature or spinning cy-
LocI-
cle.
The buzzer is deactivated
bEEP OFF
The buzzer is activated
bEEP ON
Function "Speed up" is activated
SPEEd uP
9.2 Troubleshooting with display code
Problem Cause
E1 • Drainage error, water is not fully drained
within 6 minutes
E2
• Lock - error.
F3
• Temperature sensor - error..
E4 • Water level not reached after 8 minutes.
• Drain hose is self-syphoning..
F4 • Heating error
9- Troubleshooting
Solution
•
• Check drain hose installation.
• Shut the door properly.
• Contact the After sales service..
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales service..
25