CCS Technical Documentation
3.
Insert microphone to system connector
Look at the figure above carefully.
4.
Insert LCD-module to PWB
Remove the display cover tape first. The display "face" needs to be blown with ionized air
before assembling. Focus pin at upper end of lightguide (37) to hole in PWB (11) and
screw towers of lightguide to cutouts on edge of PWB.
LCD module is properly assembled when snaps joints in metal frame (44) clicks to PWB.
Blow a LCD-module, Module and an A-cover with ionizer.
Note: Ensure that there is no any dirt on the window.
Issue 1 07/02
Assembly & Disassembly Instructions
ãNokia Corporation
NPM-2NX
Page 5