Setting the date .
10.
repeatedly to exit the menu.
Setting the time .
The time is preset by the heating contractor. Change
the time if necessary.
Tap the following buttons:
1.
press for 4 s to enter the main menu.
2.
/
. should be selected
3. "OK"
to confirm
Switching internet access on or off
You can control your system remotely via the internet
using an app. To do this, establish an internet connec-
tion via WiFi: See the following chapter.
The required credentials for internet access to the con-
trol unit via app can be found on the adjacent label:
Establishing a WiFi connection
You will need the ViCare app on your mobile device to
establish an internet connection with the heat genera-
tor.
Tap the following buttons:
1. Press "OK" for 4 s. The display will show a rotat-
ing bar until the WiFi symbol is illuminated on the
far left.
2. Start the ViCare app and follow the instructions in
the app.
flashes
darkly illuminated
brightly illuminated The connection to the server
(cont.)
The connection to the local net-
work is being established.
The connection to the local net-
work has been established.
has been established.
4.
/
to select the hour
5. "OK"
to confirm
6.
/
to select the minutes
7. "OK"
to confirm
8.
repeatedly to exit the menu.
Fault while establishing the connection
"E10" Connection to the home network cannot be
established.
Note
If "E10" appears on the display, check the con-
nection to the router and whether the network
password is correct.
"E12" Connection to the server cannot be estab-
lished.
Note
If "E12" appears on the display, re-establish
the connection at a later time.
Further settings
25