Advertisement
SAFETY CHECK-OUT
After correcting the original problem, perform the following safety
check before return the product to the costomer.
1.Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire
board surface for solder splasher and bridges.
2. Check the interboard wiring to ensure that no
wires are ìpinchedî or contact high-wattage re-
sistors.
3. Look for unauthorized replacement parts, par-
ticularly transistors, that were installed during a
previous repair. Point them out to the customer
and recommend their replacement.
4. Look for parts which, though functioning, show
obvious signs of deterioration. Point them out to
the customer and recommend their replacement.
5. Check the B + voltage to see it is at the values
specified.
2
FinePix6800Zoom(U/E/EG) SCHEMATICS
6. Make leakage - current measurements to deter-
mine that exposed parts are acceptably insulated
from the supply circuit before returning the product
to the customer.
7.
CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY WITH
RISK OF FIRE-
SAME TYPE 2.5 AMPERES 125V
2.5A125V
REPLACE FUSE
FUSE.
AS MARKED
ATTENTION: AFIN D'ASSURER
2.5A125V
UNE PROTECTION PERMANENTE
CONTRE LES RISQUES
D'INCENDIE, REMPLACER
UNIQUEMENT PAR UN FUSIBLE
DE MEME, TYPE 2.5 AMPERES,
125 VOLTS.
8.
WARNING:
TO REDUCE THE ELECTRIC
WARNING!
SHOCK, BE CAREFUL TO TOUCH
THE PARTS.
HIGH VOLTAGE
Advertisement
