Power Trim And Tilt Switch On Remote Control; Power Trim And Tilt Switch On Bottom Cowling - Yamaha VF150 Owner's Manual

With the main switch in the "
the electrical circuits are on, and the key can-
not be removed.
 "
" (start)
With the main switch in the "
sition, the starter motor turns to start the en-
gine. When the key is released, it returns
automatically to the "
ON
OFF
OFF
EMU32054
Power trim and tilt switch on remote
control
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Push-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position. For instructions
on using the power trim and tilt switch, see
pages 65 and 67.
" (on) position,
" (start) po-
" (on) position.
START
ZMU06245
ON
START
ZMU07019
" (up) trims the
UP
DN
1
1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
EMU26156
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on
the side of the bottom cowling. Pushing the
switch " " (up) trims the outboard motor up,
and then tilts it up. Pushing the switch "
(down) tilts the outboard motor down and
trims it down. When the switch is released,
the outboard motor will stop in its current po-
sition.
For instructions on using the power trim and
tilt switch, see page 67.
EWM01032
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
Components
ZMU06981
ZMU07849
"
31