Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Engine Cowling - Yamaha F60C Owner's Manual

adjuster lever is set to the "A" position.
Check the tiller handle for smooth move-
G
ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to
G
the friction areas of the steering friction ad-
juster.
EMU26143
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pressing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
For instructions on using the power trim and
tilt switch, see pages 55 and 57.
UP
DN
EMU26153
Power trim and tilt switch on bottom
" (up) trims the
engine cowling
The power trim and tilt switch is located on
the side of the bottom engine cowling. Press-
ing the switch "
motor up, and then tilts it up. Pressing the
switch "
down and trims it down. When the switch is
released, the outboard motor will stop in its
current position.
For instructions on using the power trim and
tilt switch, see page 57.
EWM01030
Use the power trim and tilt switch located
on the bottom engine cowling only when
the boat is at a complete stop with the en-
gine off. Attempting to use this switch
while the boat is moving could increase
the risk of falling overboard and could
distract the operator, increasing the risk
of collision with another boat or an obsta-
cle.
ZMU03938
Components
" (up) trims the outboard
" (down) tilts the outboard motor
WARNING
23