Function Setting - Mitsubishi Electric G-50A Instruction Book

5 - 3 Function setting

• The functions of this controller are set according to the function settings.
• The functions selects are set to OFF when the controller is shipped from the factory.
(1) Select "7 FUNCTION SETTING" (or
7
(2) Switch the function by pressing the function No. you want to change, or the
number.
Each time the switch is pressed, the ON/OFF state of that No. is switched. (NO. 1 and NO. 2 cannot be changed.)
<Operation example>
1)When Input
3
3
ON
OFF
BACK
(3) When the switch is pressed at the end of function switching, the screen returns.
SCREEN
MENU
6 ADDRESS SETTING
7 FUNCTION SETTING
8 IP ADDRESS SETTING
BACK
<Function selects>
No. 1 Reserved for future use (Leave this switch set to OFF)
No. 2 Reserved for future use (Leave this switch set to OFF)
No. 3 OFF: No K transmission converter installed
No. 4 OFF: Operation prohibit setting valid
No. 5 OFF: Emergency stop broadcast enabled (Be sure to use)
No. 6
External input changeover (refer to section "7. External input/output function")
No. 7
No. 8 The range of a controller which the operation is prohibited
OFF: Both of the system controller and the local remote controller
switch was pressed.
3
ON
: Active
OFF
Press the
to select "7 FUNCTION
WED 15:29
SETTING"
"2 FUNCTION SETTING").
2
switch
7
FUNCTION SETTING
Press the BACK
SCREEN
switch to go back
to the initial
setting menu.
– 26 –
to switch of the same
1 8
1 2 3 4 5 6 7 8
ON
OFF
ON: K transmission converter installed
ON: Operation prohibit setting invalid
ON: Emergency stop broadcast disabled
ON: Only the local remote controller