Biostar M6VLR User Manual page 53

Chapter 2
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If install and FDC or the system has no
floppy drive, select Disabled in this field.
The Choices: Enabled (default), Disabled.
Onboard Serial Port 1
Select an address and corresponding interrupt for the first and second serial ports.
The Choices: Auto (default), Disabled, 3F8/IRQ4, 2F8/IRQ3,
3E8/IRQ4, 2E8/IRQ3.
Onboard IR Port
Select IR Address.
The Choices: Auto, 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4,
UART 2 Mode
This item allows you to determine which Infrared (IR) function onboard I/O chip.
The Choices: HPSIR (default), ASKIR.
IR Function Duplex
This item allows you to decide to active IR transmission delay.
The Choices: Half (default), Full.
TX, RX inverting enable
This item allows you to determine the active of Rx,Tx.
The Choices: No/Yes (default), No/No, Yes/No, Yes/Yes.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Onboard Parallel Mode
The default value is Normal.
EPP
2E8/IRQ3, Disabled (default).
Using Parallel Port as Enhanced Parallel
2-19
BIOS Setup