The Jog Operation - Omron OMNUC W Series User Manual

Chapter 4 The way of operating
4-6

The JOG operation

It is possible to do the JOG operation of the motor from WMON Win.
During JOG operation, the input of control entry signal (CN1) becomes invalid.
Go in the condition which doesn't put a load to the motor.
Caution: JOG operation, confirm that there are not a person and an obstacle
around the motor and the machine.
Also, during operation, don't do the pulling-out shine of the cable, the
stopping of the personal computer monitor software, the quitting of the
personal computer.
Possible in the damaging of equipment
The JOG operation operates by the following procedure.
1. It off the operation preparation signal (RUN) of the control entry signal (CN1)
of servo driver.
2.
It connects with the servo driver by the procedure of " 4-2 Servo driver connection and the
connection blocking-off ".
3. It clicks 【JOG】 from 【Operations】menu.
The following screen is displayed.
4. It sets JOG speed.
5. It becomes JOG operation mode in case of pushing the "Enable" button of 【Mode】
and lamp's becoming green.
6. It begins in the turning on at the motor in case of pushing the "Enable" button of
【Servo】 and lamp's becoming green.
7. The motor turns at the JOG speed at the button.
8. When ending JOG operation, do 4 - 6 procedures oppositely.
4-11